Event ID |
Event Logged |
Comments |
102 |
|
One of the queues has initiated a callback |
2013 |
|
The disk is at or near capacity (Windows Server OS Only) |
4097 |
Service started |
Service has been started |
4098 |
Service got signal to stop: %1 |
Service is about to stop |
4099 |
Emergency number (%1) is dialed from %2 |
An emergency number was dialed |
4100 |
Trunk %1 has changed status to %2 |
The status of a trunk has changed |
4101 |
Extension %1 is %2%3 |
The registration status of an extension has changed |
8193 |
License limit is reached, active calls: %1 |
A call request was received in excess of the License Key limit of simultaneous calls |
12289 |
Device %1 had no available outgoing trunk(s) for Call(%2) |
An outbound call request over a trunk failed because over the maximum number of calls available through that trunk |
12290 |
The IP %1 has been blacklisted for %2 sec. Reason: %3 |
An IP Address has been blacklisted |
12291 |
SIP request (%1) from %2 was rejected. Reason: %3. Message: %4 |
|
12292 |
The IP %1 has been blacklisted for %2 sec. Reason: requests rate is too high! |
A request was rejected/blocked by the Anti-Hacking module – security breach detected |
12293 |
Registration at %1 has failed. Destination (%2) is not reachable, DNS error resolving FQDN, or service is not available. |
DNS resolution failed or cannot reach remote VoIP Provider |
12294 |
Call to %1 has failed. %2 replied: %3 |
Destination responded with an error code (eg. service unavailable, user not found, insufficient credit, account disabled) – contact trunk provider |
12295 |
STUN server %1:%2 could not be reached%3 It could be that the STUN server you are using is down or a network problem is preventing STUN resolutions. This might cause problems if you use VoIP Providers. |
STUN resolution has failed, timed out, or no backup STUN servers could resolve |
12296 |
Call from [%2] to [%1] has been rejected by the 3CX Country Blocking Feature [%3]. Reason: %2 contains Prefix %3. Calls to %3 are not allowed by system. Resolution: To allow this call access the 3CX Management Console, Settings, General, and enable the country or continent that matches this prefix. |
Outbound call has been rejected because its country code is not on the Allowed Country Codes |